LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Instrument Panel And Console) >> Removal And Installation >> Console - Front Floor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor shifter trim ring.
  2. Remove the floor console center finish panel.
    3. NOTE: Five Hundred, Montego shown; Freestyle similar.
    Fig 1: Removing Floor Console Front Screws
    G04659022Courtesy of FORD MOTOR CO.
  3. Remove the 2 floor console front screws.
  4. Remove the floor console LH and RH finish panels.
    • To install, apply 110 N.m (81 lb-ft) of force to the Dylock area in the front of the panel.
  5. Remove the 4 front floor console bolts.
  6. Remove the 2 front floor console-to-instrument panel screws.
    • To install, tighten to 5 N.m (44 lb-in).
  7. Disconnect the electrical connectors.
  8. Remove the floor console.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals