LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 566 (Fuel Tank & Lines) >> Removal And Installation >> Inertia Fuel Shutoff (IFS) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the RH cowl side trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Disconnect the inertia fuel shutoff (IFS) switch electrical connector.
  4. Remove the 2 IFS switch retaining bolts.
    • To install, tighten to 12 N.m (9 lb-ft).
  5. Remove the IFS switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals