LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 530 (Engine) >> In-Vehicle Repair >> Camshaft Roller Follower >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the LH and RH valve covers. For additional information, refer to VALVE COVER - LH  and VALVE COVER - RH .
  3. Remove the 6 spark plugs.
    • To install, tighten to 15 N.m (11 lb-ft).
  4. Remove the RH splash shield.
    • To install, tighten to 9 N.m (80 lb-in).
  5. Rotate the crankshaft until the camshaft lobe is pointing directly away from the roller follower.
  6. Using the special tool, remove the roller followers.
    Fig 1: Removing Roller Followers
    G04655698Courtesy of FORD MOTOR CO.
    7. NOTE: Lubricate the camshaft followers with clean engine oil.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals