Removal and Installation
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- If equipped, remove the front license plate frame.
- Remove the 3 fog lamp bracket bolts and the fog lamp and bracket assembly.
- Disconnect the electrical connector.
- To install, tighten to 5 Nm (44 lb-in).
- Remove the fog lamp adjustment bolt.
- Remove the 2 fog lamp pin-type retainers.
- Pull outward on the retaining tabs and remove the fog lamp.
- To install, reverse the removal procedure.
- If necessary, adjust the fog lamps. For additional information, refer to FRONT FOG LAMP ADJUSTMENT .