DIGITAL TRANSMISSION RANGE (TR) Sensor: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the TR sensor and detent lever assembly.
1. Connect the park rod to the detent lever assembly.
2. Install the TR sensor and the detent lever assembly.
3. Loosely install the bolts.
  
  Fig 1: Identifying TR Sensor And Detent Lever Bolts
  Courtesy of FORD MOTOR CO.
Install the manual control lever shaft.

Fig 2: Identifying Manual Control Lever Shaft Assembly
Courtesy of FORD MOTOR CO.

NOTE: Leave a small portion of the pin exposed.

Fig 3: Identifying Manual Valve Detent Lever Shaft Retaining Pin

Courtesy of FORD MOTOR CO.

Install the manual valve detent lever shaft retaining pin into the case.

NOTE: When the retaining pin is installed correctly, 2 mm (0.08 in) of the pin will be exposed.

Fig 4: Locating Manual Valve Detent Lever Shaft Retaining Pin

Courtesy of FORD MOTOR CO.

Install a new manual valve detent lever shaft retaining pin.
Tighten the bolts to 10 Nm (89 lb-in).

Fig 5: Locating Transmission Range (TR) Position Sensor Bolts
Courtesy of FORD MOTOR CO.
Connect the TR sensor electrical connector.

Fig 6: Identifying Transmission Range Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Connect the shift cable end.

Fig 7: Locating Selector Lever Cable End
Courtesy of FORD MOTOR CO.
Install the transmission fluid pan, gasket and filter. For additional information, refer to FLUID PAN, GASKET AND FILTER .
Adjust the shift linkage. Verify that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .