LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 448 (Electronic Engine Control System - Gasoline - F250-F550 Super Duty) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 5.4L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the CMP sensor electrical connector.
  3. Remove the bolt and the CMP sensor. Discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    • Lubricate the O-ring seal with clean engine oil prior to installation.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals