LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 433 (Front Drive Axle/Differential -- F250-F550 Super Duty) >> In-Vehicle Repair >> Axle Shaft Seal >> Installation

Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new axle shaft dust seal.
    Fig 1: Installing Axle Shaft Seal
    G04644239
  2. Install the new main seal onto the axle shaft.
    1. Position the main seal onto the axle shaft.
    2. Using the special tools and a soft-faced hammer, seat the main seal onto the axle shaft.
      Fig 2: Installing Main Seal Onto Axle Shaft
      G04644240
  3. Position the axle shaft into the shaft housing.
  4. Using the special tools and a soft-faced hammer, install the main seal into the wheel knuckle.
    Fig 3: Installing Main Seal Into Wheel Knuckle
    G04644241
  5. Install the wheel hub and bearing. For additional information, refer to FRONT SUSPENSION - FOUR WHEEL DRIVE (4WD) .
scientia non olet · About LEMON Manuals