LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 428 (Front Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Front Disc Brake Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    4WD vehicles 

  1. The wheel bearing and hub must be removed prior to removing the brake disc shield. Remove the wheel bearing and hub. For additional information, refer to FRONT SUSPENSION - FOUR WHEEL DRIVE (4WD) .

    2. RWD vehicles 

  2. Remove the brake disc. For additional information, refer to BRAKE DISC .
  3. Remove the brake disc shield screws and the brake disc shield.
    • To install, tighten to 11 Nm (8 lb-ft).

    4. All vehicles 

  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals