LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 414 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender Splash Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 fender splash shield bolts.
    • To install, tighten to 8 Nm (71 lb-in).
  2. Remove the 7 fender splash shield pin-type retainers.
  3. Remove the 6 fender splash shield screws.
  4. Remove the fender splash shield.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals