Selector Lever Cable Adjustment

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: The ignition must be in the OFF position to make sure that the eCVT and the engine are OFF.

With the ignition in the OFF position and in DRIVE, raise the vehicle on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the LH splash shield.

Fig 1: Locating Retainers For LH Splash Shield
Courtesy of FORD MOTOR CO.
Remove the transaxle control splash shield.

Fig 2: Locating Transaxle Control Splash Shield
Courtesy of FORD MOTOR CO.
Loosen the selector lever cable adjustment screw.

Fig 3: Locating Selector Lever Cable Adjustment Screw
Courtesy of FORD MOTOR CO.
Loosen the selector lever cable bracket nuts so that the selector lever is free to move.

Fig 4: Locating Selector Lever Cable Bracket Nuts
Courtesy of FORD MOTOR CO.
Position the selector lever between the 2 ribs on the transaxle case.

Fig 5: Positioning Selector Lever Between Ribs On Transaxle Case
Courtesy of FORD MOTOR CO.
Lower the vehicle to access the selector lever.
Place the transmission selector lever in the D position.
Tighten the selector lever cable adjustment screw to 8 Nm (71 lb-in).
Tighten the selector lever cable bracket nuts.
- Tighten to 22 Nm (16 lb-ft).
To verify the correct adjustment, observe the selector lever on the transaxle, while an assistant shifts the transmission selector lever to each range position ending in the D position.
Install the transaxle control splash shield.
- Tighten to 15 Nm (11 lb-ft).
Fig 6: Locating Transaxle Control Splash Shield
Courtesy of FORD MOTOR CO.
Install the LH splash shield.

Fig 7: Locating Retainers For LH Splash Shield
Courtesy of FORD MOTOR CO.