LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Exterior Trim And Ornamentation) >> Removal And Installation >> Roof Rack >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 4 screws and the roof rack air deflector. To install, tighten to 5 Nm (44 lb-in).
    NOTE: Individual components can be removed without following the entire sequence shown. LH and RH stopblocks are not interchangeable. Have an assistant help with sliding the inner roof rack assembly from the upper slide rails.
  2. Remove the 2 screws and the 2 roof rack inner rack stop blocks.
    • To install, tighten to 4 Nm (35 lb-in).
  3. Remove the roof rack inner rack.
  4. Remove the 2 screws and the roof rack cross bar.
    • To install, tighten to 4 Nm (35 lb-in).
  5. Remove the 6 screws and the 2 roof rack side bars.
    • To install, tighten to 2 Nm (18 lb-in).
  6. Remove the 8 screws and the 2 roof rack side bar bases.
    • To install, tighten to 2 Nm (18 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals