LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 393 (Engine Emission Control - 3.0L (4V)) >> Removal And Installation >> Differential Pressure Feedback Exhaust Gas Recirculation (EGR) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the differential feedback EGR system sensor electrical connector and detach the wiring retainer.
  3. Carefully detach the differential feedback EGR system sensor vacuum tubes and remove the sensor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals