Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 2 bolts and the RH splash shield.
- To install, tighten to 7 Nm (62 lb-in).
- Loosen the power steering pump pulley bolt.
- Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.
- Remove the nut and the power steering pump pulley.
- To install, tighten to 61 Nm (45 lb-ft).
- To install, reverse the removal procedure.