LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 346 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the camshaft position sensor (CMP) sensor electrical connector.
  3. Remove the bolt and the CMP.
    • To install, tighten to 7 Nm (62 lb-in).
    • Inspect the O-ring seal and install new as necessary.
  4. To install, reverse the removal procedure.
    NOTE: Lubricate the CMP O-ring seal with clean engine oil.
scientia non olet · About LEMON Manuals