LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 334 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate - Hybrid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the battery junction box (BJB) fuses 24 (50A) and 31 (50A).
  3. Remove the brake pads. For additional information, refer to BRAKE PADS - HYBRID .
  4. Remove the 2 brake caliper anchor plate bolts.
    • To install, tighten to 175 Nm (129 lb-ft).
  5. Remove the brake caliper anchor plate.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals