LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Transfer Case -- F250-F550 Super Duty) >> In-Vehicle Repair >> Transfer Case Shift Lever >> Removal

Transfer Case Shift Lever: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift the transfer case into 4H.
  2. Remove the screws that attach the bezel and boot assembly to the floor.
    Fig 1: Identifying Bezel And Boot Assembly Screws
    G03909667Courtesy of FORD MOTOR CO.
  3. Remove the bolt that attaches the shift lever to the transfer case control lever assembly, and remove the shift lever, and the bezel and boot assembly.
    1. Slide the bezel and boot assembly upward on the shift lever.
    2. Remove the bolt, the shift lever, and the bezel and boot assembly.
      Fig 2: Removing Bolt, Shift Lever, And Bezel And Boot Assembly
      G03909660Courtesy of FORD MOTOR CO.
  4. Raise and support the vehicle. For additional information, refer to JACKING AND LIFTING .
  5. Disconnect the control rod from the lower shifter arm.
    Fig 3: Disconnecting Control Rod From Lower Shifter Arm
    G03909661Courtesy of FORD MOTOR CO.
  6. Remove the bolt and the transfer case control lever assembly. Discard the bolt.
    Fig 4: Removing Bolt And Transfer Case Control Lever Assembly
    G03909662Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals