LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Luggage Compartment Lid Lock Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
  1. Remove the license plate housing. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION .
  2. Release the clips and disconnect the luggage compartment lid lock cylinder cable.
  3. If equipped, disconnect the luggage compartment anti-theft inhibit switch electrical connector.
  4. Remove the 2 luggage compartment lid lock cylinder rivets.
  5. Remove the luggage compartment lid lock cylinder.
  6. To install, reverse the removal procedure.
    • Use the special tool to install the new rivets.
scientia non olet · About LEMON Manuals