LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch Release Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the hood latch. For additional information, refer to HOOD LATCH .
  3. Release the hood latch release cable locators.
  4. Remove the bolt, the nut and the hood latch release handle and cable.
    • To install, tighten to 5 Nm (44 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals