LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Front Door Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Remove the 3 rivets and position the interior door handle remote control aside.
  4. Open the clip and release the exterior door handle actuating rod.
  5. If equipped, disconnect the door lock cylinder actuating rod from the door lock cylinder.
  6. Disconnect the door ajar switch electrical connectors.
  7. Disconnect the door lock actuator electrical connector.
  8. Remove the door lock actuator rivet.
  9. Remove the 3 screws and the front door latch.
    • To install, tighten to 6 Nm (53 lb-in).
  10. To install, reverse the removal procedure.
    • Use the special tool to install the new rivets.
scientia non olet · About LEMON Manuals