LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Interior Trim And Ornamentation) >> Removal And Installation >> B-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front and rear door scuff plates.
  2. Position the front and rear door weatherstrips aside.
  3. Remove the lower B-pillar trim panel.
  4. Remove the safety belt D-ring cover.
  5. Remove the safety belt D-ring bolt.
    • To install, tighten to 40 Nm (30 lb-ft).
  6. Remove the screw and the upper B-pillar trim panel.
  7. To install, reverse the removal procedure.
    • Check the restraint system for correct operation.
scientia non olet · About LEMON Manuals