LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Engine Emission Control System) >> Removal And Installation >> Crankcase Ventilation Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

    LH crankcase ventilation tube 

  1. Release the LH crankcase ventilation tube quick connect coupling from the throttle body (TB) inlet tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  2. Release the LH crankcase ventilation tube quick connect coupling from the LH valve cover crankcase vent tube nipple and remove the tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .

    3. RH crankcase ventilation tube 

  3. Release the RH crankcase ventilation tube quick connect coupling from the TB adapter. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  4. Release the RH crankcase ventilation tube quick connect coupling from the positive crankcase ventilation (PCV) valve and remove the tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .

    5. RH and LH crankcase ventilation tubes 

  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals