LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (Engine Cooling System) >> Removal And Installation >> Cooling Fan Motor and Shroud >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  3. Remove the bolt and position aside the power steering reservoir.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Disconnect the degas bottle overflow hose and the supply hose and position aside.
  5. Remove the bolt and the degas bottle.
    • To install, tighten to 10 Nm (89 lb-in).
  6. Disconnect the upper radiator hose and position aside.
  7. Detach the transmission cooler tubes from the cooling fan motor and shroud.
  8. Disconnect the cooling fan motor and shroud electrical connector.
    9. NOTE: Position the lower radiator hose away from the cooling fan motor and shroud.
  9. Remove the 2 bolts and the cooling fan motor and shroud assembly.
    • To install, tighten to 10 Nm (89 lb-in).
    10. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  10. To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
  11. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals