Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
- Using a suitable suction device, remove the power steering fluid from the reservoir.
- Release the clamps and disconnect the hoses.
- Remove the bolt and the reservoir.
- To install, tighten to 12 Nm (9 lb-ft).
- To install, reverse the removal procedure.
- Fill and check the system for leaks. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .