Torque Of Generator-AC (TGAC) Signal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

The transaxle control module (TCM) calculates an AC generator torque from an AC current measured by the current sensor which is located inside the transaxle. The TGAC is a 50% duty cycle signal which the TCM sends to the PCM over the TGAC circuit. The TCM also broadcasts a redundant generator torque message to the PCM over the communication link. The typical TGAC signal ranges from 200 Hz to 400 Hz, where 300 Hz is equal to 0 Nm (0 lb ft) of torque, 200 Hz is equal to 250 Nm (185 lb ft) of negative torque, and 400 Hz is equal to 250 Nm (185 lb ft) of positive torque. The PCM uses the generator torque value as an input to the energy management control strategy, the torque monitor strategy, and the regenerative brake torque limits strategy. In the event of TGAC circuit failure the PCM initiates limited operating strategy (LOS) shutdown mode which disables the vehicle. The PCM also stores an appropriate DTC.