DTC P0458: Evaporative Emission System Purge Control Valve Circuit Low
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0458 - EVAPORATIVE EMISSION SYSTEM PURGE CONTROL VALVE CIRCUIT LOW
| Description: | The powertrain control module (PCM) monitors the state of the evaporative emission (EVAP) canister purge valve circuit output driver. The test fails when the signal moves outside the minimum or maximum limit for the commanded state. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | To verify normal function, monitor the EVAP canister purge valve signal PID EVAPCP. With the valve closed, the EVAPCP indicates 0% duty cycle. When the valve is commanded fully open, the EVAPCP indicates 100% duty cycle. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST HZ . | ||