DTC P1309: Misfire Monitor Hardware - Camshaft Position Sensor (CMP) Misaligned, Crankshaft Position Sensor (CKP)/CMP Noise, Powertrain Control Module (Pcm) AICE Chip
WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Mariner, and 2006 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1309 - MISFIRE MONITOR HARDWARE - CAMSHAFT POSITION SENSOR (CMP) MISALIGNED, CRANKSHAFT POSITION SENSOR (CKP)/CMP NOISE, POWERTRAIN CONTROL MODULE (PCM) AICE CHIP
| Description: | When the misfire monitor is disabled, usually due to the input signal generated by the camshaft position (CMP) sensor, by sensing the passage of teeth from the CMP wheel. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the CMP sensor is installed correctly and is not out of synchronization. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | - | - | GO to Pinpoint Test HD . |