Section 216 (Engine Controls - Diagnostic Methods (Except Diesel & Hybrid))
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Milan, and 2006 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Methods
- Diagnostic Tools
- Diagnostic Tool Setup And Functionality
- Vehicle Check/Preparation
- Quick Test
- Parameter Identification (PID)
- On-Board System Readiness (OSR)
- Freeze Frame Data
- Output State Control (OSC)
- Output Test Mode (OTM)
- Clear The Continuous Diagnostic Trouble Codes (DTCS) And Reset The Emission Monitors Information In The Powertrain Control Module (Pcm)
- Resetting The Keep Alive Memory (KAM)
- Flash Electrically Erasable Programmable Read Only Memory (EEPROM)
- Diagnostic Monitoring Test Results - Mode 6
- On Board Diagnostic (OBD) Drive Cycle
- Intermittent Diagnostic Techniques
- Adaptive Fuel DTC Diagnostic Techniques
- Notes
- Obtain Freeze Frame Data
- Using the LONGFT1 and LONGFT2 (Dual Bank Engines) PIDs
- Resetting Long Term Fuel Trims
- P0171/P0174 System Too Lean Diagnostic Aids
- Air Measurement System
- Vacuum Leaks/Unmetered Air
- Insufficient Fueling
- Exhaust System Leaks
- P0172/P0175 System Too Rich Diagnostic Aids
- Fuel System
- Air Inlet System
- Base Engine
- Basic Circuit Checks