Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear bumper cover. For additional information, refer to BUMPER SYSTEM -- FUSION, MILAN & MKZ article.
- Disconnect the parking aid sensor(s) electrical connector(s).
- Pry the retaining tabs with a suitable tool, such as a flat bladed screwdriver and remove the parking aid sensor(s).
- To install, reverse the removal procedure.
- Carry out the azimuth and elevation system check. For additional information, refer to AZIMUTH SYSTEM CHECK and ELEVATION SYSTEM CHECK in this service information.