LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2104 (Electronic Engine Controls - 2.5L (Except Hybrid)) >> Removal And Installation >> Variable Camshaft Timing (VCT) Oil Control Solenoid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the valve cover. For additional information, refer to ENGINE MECHANICAL - 2.5L -- FUSION & MILAN (EXCEPT HYBRID) article.
  2. Remove the bolt and the Variable Camshaft Timing (VCT) oil control solenoid.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals