LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2101 (Instrument Panel & Console) >> Removal And Installation >> Instrument Cluster Finish Panel - MKZ >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the 2 instrument cluster finish panel screws covers and remove the 2 instrument cluster finish panel screws.
  2. Remove the steering wheel. For additional information, refer to STEERING COLUMN article.
  3. Remove the multifunction switch. For additional information, refer to STEERING COLUMN SWITCHES article.
  4. Remove the LH instrument panel finish panel.
    • Pull the LH instrument panel finish panel toward the rear of the vehicle to release the retaining clips.
  5. Remove the instrument cluster finish panel.
    • Pull the instrument cluster finish panel toward the rear of the vehicle to release the retaining clips.
  6. To install, reverse the removal procedure.
    • If replacing the instrument cluster finish panel, remove the 2 register screws and transfer the register.
    • Make sure to align the LH instrument panel finish panel retaining clips to the retaining clip holes in the instrument panel.
scientia non olet · About LEMON Manuals