Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the fender splash shield. For additional information, refer to FRONT END BODY PANELS -- FUSION, MILAN & MKZ article.
- Disconnect the wheel speed sensor electrical connector.
- Remove the wheel speed sensor harness bracket-to-body bolt.
- To install, tighten to 7 Nm (62 lb-in).
- Detach the wheel speed sensor harness from the wheel knuckle bracket.
- Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).
- To install, reverse the removal procedure.