Rear Disc Brake Shield - All Wheel Drive (AWD): Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Transfer the index mark from the removed brake disc shield to the new brake disc shield.
Position the brake disc shield onto the wheel knuckle.
Align the index marks and install the brake disc shield onto the wheel knuckle using the Front Subframe Bushing Remover/Installer.

Fig 1: Installing Brake Disc Shield Onto Wheel Knuckle Using Front Subframe Bushing Remover/Installer

Courtesy of FORD MOTOR CO.