LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2091 (Power Transfer Unit (PTU)) >> Removal >> Intermediate Shaft Seal - 6F35 >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL(S)

G07786912
Remover, PTO Driven Gear Oil Seal
308-428
G07786913
Slide Hammer
100-001 (T50T-100-A)
    NOTE: Red Automatic Transmission Fluid (ATF) leaking from the RH side of the Power Transfer Unit (PTU) indicates a faulty intermediate shaft seal. For additional information, refer to ANALYSIS OF LEAKAGE  in this service information.
  1. Remove the PTU. For additional information, refer to POWER TRANSFER UNIT (PTU)  in the service information.
  2. Using the PTO Driven Gear Oil Seal Remover and Slide Hammer, remove the intermediate shaft seal.
    Fig 1: Removing Intermediate Shaft Seal Using PTO Driven Gear Oil Seal Remover And Slide Hammer
    G07786914Courtesy of FORD MOTOR CO.