Instrument Panel Cluster (IPC): Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Position the IPC in the instrument panel and connect the electrical connector.
- Install the 3 screws.
- Install the IPC finish panel. Refer to INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ article.
- If a new IPC was installed, updated or reconfigured, carry out the parameter reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) -- FUSION, MILAN & MKZ (non-hybrid) article or ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) -- FUSION, MILAN & MKZ (HYBRID) (hybrid) article.
- If a new IPC was installed, program the integrated keys. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) -- FUSION, MILAN & MKZ (non-hybrid) article or ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) -- FUSION, MILAN & MKZ (HYBRID) (hybrid) article.
- If a new IPC was installed, download the IPC configuration information from the scan tool into the new IPC . For additional information, refer to MODULE CONFIGURATION -- FUSION MILAN & MKZ article, PMI.
NOTE:
If a new IPC
is installed, updated, or re-configured, the IPC
and the PCM (non-hybrid) or Transmission Control Module (TCM) (hybrid) require a parameter reset to allow the IPC
and the PCM or TCM to recognize each other. Failure to carry out the parameter reset to the IPC
and the PCM or TCM can result in a no start condition.
NOTE:
The vehicles integrated keys (or standard Passive Anti-Theft System (PATS) keys) must be programmed to the new IPC
.