Front Fog Lamp Adjustment Screw Location
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Before starting the fog lamp assembly adjustment:
- make sure the vehicle is on level ground.
- check the tire inflation.
- make sure there are no other loads in the vehicle other than a half tank of fuel.
- make sure the fog lamps and headlamps are clean.
- make sure the headlamps are operating and are correctly aimed.
- Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
- Measure the distance from the floor to the center of the fog lamp.
- The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.
- Rotate the adjustment screw until the fog lamp beam is within specification.
NOTE:
Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
NOTE:
The vertical wall screen must be a minimum of 2.4 m (8 ft) wide.
Fig 2: Parking Vehicle On Level Surface Approximately 7.6 m (25 ft) From Vertical Wall Or Screen Directly In Front Of It