Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the A/C compressor. For additional information, refer to CLIMATE CONTROL -- FUSION, MILAN & MKZ article.
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING & CABLES -- FUSION, MILAN & MKZ article.
- Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (106 lb-in).
- Disconnect the generator electrical connector.
- Remove the 3 bolts and the generator.
- To install, tighten to 47 Nm (35 lb-ft).
- To install, reverse the removal procedure.