LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2055 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY  in this service information.
  3. Using the Oil Seal Remover, remove and discard the crankshaft front seal.
    • Clean all sealing surfaces with metal surface prep.
    Fig 1: Removing Crankshaft Front Seal Using Oil Seal Remover
    G07784502Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals