LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2054 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Installation

Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new O-ring seal on the oil pump screen and pickup tube.
    • Lubricate the O-ring seal with clean engine oil.
  2. Install the oil pump screen and pickup tube.
    1. Position the oil pump screen and pickup tube.
    2. Install the bolts and tighten to 10 Nm (89 lb-in).
    Fig 1: Identifying Bolts, Oil Pump Screen And Pickup Tube
    G07781441Courtesy of FORD MOTOR CO.
  3. Install the oil pan. For additional information, refer to OIL PAN  in this service information.
scientia non olet · About LEMON Manuals