DTC P1145: (TCM) - Calculated Torque Error
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P1145 (TCM) - CALCULATED TORQUE ERROR
| Description: | The transaxle control module (TCM) continuously monitors the controller area network (CAN) for calculated torque message from the powertrain control module (PCM). This DTC is set when the calculated torque is not within the expected range. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the TCM TQ_DSD parameter identification (PID). The PID value should be positive in DRIVE or LOW, negative in REVERSE, 0 Nm (0 lb ft) in PARK or NEUTRAL if the brake pedal is not applied. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST TU . | ||