LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Parking Aid System) >> Removal And Installation >> Parking Aid Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    Sedan 

  1. Remove the rear bumper cover. For additional information, refer to BUMPERS .

    2. Wagon 

  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .

    3. All vehicles 

  3. Disconnect the parking aid sensor electrical connector.
    4. NOTE: Press the retaining tabs to release the sensor(s).
  4. Remove the parking aid sensor(s).
  5. To install, reverse the removal procedure.
    • Paint the sensor(s) with one coat of paint (basecoat and clear coat).
    • Using the diagnostic tool, verify that the parking aid sensor PIDs read no object present, and that the parking aid sensor attenuation PIDs read between 0.8 - 1.6 ms. If the parking aid sensor attenuation PIDs do not read between 0.8 - 1.6 ms, the paint is too thick on the sensor(s) and it will be necessary to repaint the sensor(s) as required.
scientia non olet · About LEMON Manuals