Safety Belt Twisted at the Safety Belt Guide

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: These procedures apply to both wire-formed and stamped D-ring designs.

Grasp the safety belt webbing at the D-ring and fold the twisted portion of the belt webbing over itself.

Fig 1: Identifying Safety Belt Webbing At Shoulder Belt Guide (D-ring)
Courtesy of FORD MOTOR CO.
Feed the folded portion of the safety belt webbing through the safety belt guide (D-ring) to remove the twist from the belt webbing.

Fig 2: Identifying Twist From Belt Webbing
Courtesy of FORD MOTOR CO.