Roof Opening Panel Trim - Side: Removal
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ditch mouldings and clip strip.
- Remove the end cap.
- Begin cutting the urethane adhesive at the rear of the side trim panel while bending the trim panel upward as needed for access. Work forward through all urethane adhesive and rubber net pads. Remove and discard the side trim panel.
WARNING:
Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
WARNING:
Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.
NOTE:
Protect the painted roof area next to the side trim panel to prevent damage to the paint.
NOTE:
Make sure the cutting blades are changed where the cutting depth changes to avoid damage to the body or glass panel seals.
NOTE:
Lubricate the urethane adhesive with water to aid the Deluxe Windshield Removal Tool when cutting the urethane adhesive. When using the Deluxe Windshield Removal Tool, place the flat side of the knife against the side trim panel.
NOTE:
Position the sliding glass panel as required for necessary access.