Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Position the sunshade(s) to the fully OPEN position.
- Carefully bend/pry the trim ring from its hook-and-loop tape pads.
- Carefully bend the roof opening panel interior fixed glass trim and working from one corner remove the roof opening panel interior fixed glass trim.
- To install, reverse the removal procedure.
NOTE:
A piece of paper may assist in keeping the hook-and-loop tape from sticking while aligning the trim ring. Once the trim ring is in position (front and rear locating pins lined up), remove the paper and press the trim firmly in place.