Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Open the roof opening panel to the VENT position.
Detach the top of the concertina blind from the moving glass frame.
Reposition the sliding glass panel to any position rearward of VENT position.
Remove the 4 roof opening panel glass front screws.
- To install, tighten to 8 Nm (71 lb-in).
  
  Fig 1: Locating Roof Opening Panel Glass Front Screws
  Courtesy of FORD MOTOR CO.
Remove the 2 roof opening panel glass rear screws.
- To install, tighten to 8 Nm (71 lb-in).
  
  Fig 2: Locating Roof Opening Panel Glass Rear Screws
  Courtesy of FORD MOTOR CO.

NOTE: It is possible for the idler mechanism to move freely once the glass panel is removed. Do not move the idler rearward or it may disengage from the idler track.

Carefully remove the roof opening panel glass.
To install, reverse the removal procedure.
- Initialize the roof opening panel motor(s). For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .