Roof Opening Sliding Glass Panel

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The sliding glass panel has one-touch open, one-touch close and one-touch vent open features.

To operate the sliding glass panel to the VENT position, the sliding glass panel must first be in the CLOSED position. Press and release the TILT control switch. The shade panels will automatically move to the fully OPEN position (if shades are not already fully open) followed by the sliding glass panel moving to the VENT position. To close the sliding glass panel from the VENT position, pull and hold the TILT control switch.

To operate the sliding glass panel to the fully OPEN position, the shade panels must first be in the OPEN position. Press and release the roof opening panel control switch. The sliding glass panel will automatically open to the comfort position. Press and release the switch again, and the sliding glass will move to the fully OPEN position.

To operate the sliding glass panel to the fully CLOSED position, pull and release the roof opening panel control switch. The sliding glass panel will automatically close to the safety stop position (approximately 280 mm (11.023 in) from the fully CLOSED position). To fully close the sliding glass panel from the safety stop position, pull and hold the roof opening panel control switch.