Roof Opening Panel: Notes
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
The roof opening panel consists of the following:
- Air deflector
- Concertina blinds
- Fixed glass front seal
- Fixed glass side seals
- Front shade assembly
- Front trim panel
- Front trim panel seal
- Guide track and mechanism
- Idler track and mechanism
- Motor wiring harness
- Overhead console control switch
- Rear shade assembly
- Roof opening panel fixed glass
- Roof opening panel shade motor
- Roof opening panel sliding glass
- Roof opening panel sliding glass motor
- Rear trim ring assembly
- Shade motor block and drive tube assembly
- Shade track and mechanism
- Sliding front panel motor block and drive tube assembly
- Sliding glass primary seal
- Side trim panel
- Side trim panel seals
NOTE:
The roof opening panel control switch operates both the power shade and the sliding glass panel. Any glass opening operation will first fully open the shade panels. Before the shade panels may be closed, the glass panel must be fully closed.
NOTE:
One-touch open/close/vent operation can be cancelled anytime the shade panels or sliding glass is moving by activating the roof opening panel control switch or TILT control switch in either direction.