LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2023 (Body Panel System - Body Closures) >> Removal And Installation >> Door Check Arm >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the door check arm-to-body bolt.
    • To install, tighten to 20 Nm (177 lb-in).
  3. Remove the door check arm-to-door nuts.
    • To install, tighten to 9 Nm (80 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals