Power Liftgate Awake/Sleep Status

• The LTM  is in the awake state whenever the ignition is in the RUN position.
• The LTM  is in the awake state while carrying out a close or an open operation, including cinch.
• The LTM  is in the sleep state when all of the following conditions exist:
  • The latch is not in the fully unlatched position.
  • The ignition is in the OFF position.
  • No power operation is active.
  • No wakeup inputs have changed state for more than 20 seconds.
• The LTM  is also in the sleep state when all of the following conditions exist:
  • The latch is in the unlatched position.
  • The ignition is in the OFF position.
  • No power operation is active.
  • No wakeup inputs have changed state for more than 6 hours.

The wakeup inputs for the power liftgate are:

• Power liftgate open/close switch request signal
• Forkbolt primary signal
• Forkbolt secondary signal
• Detent switch signal
• Rear control switch
• Exterior handle switch
• Glass/liftgate ajar switch
• CAN