Removal and Installation
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the PAM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
- Remove the LH rear quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Remove the 2 nuts and the PAM
.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
- Download the configuration information to the PAM . For additional information, refer to MODULE CONFIGURATION to carry out PMI .
NOTE:
Module configuration is only required if a new Parking Aid Module (PAM) is being installed.