LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2022 (Parking Aid System) >> Diagnosis And Testing >> Parking Aid >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of electrical damage.
    VISUAL INSPECTION CHART

    Electrical
    • Smart Junction Box (SJB) fuse 35 (10A)
    • Wiring, terminals or connectors
    • Parking Aid Module (PAM)
    • Parking aid sensors
    • Parking aid speaker
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
    5. NOTE: The Vehicle Communication Module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM  .
  5. If the scan tool does not communicate with the VCM  :
    • Check the VCM  connection to the vehicle.
    • Check the scan tool connection to the VCM  .
    • Refer to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • Verify the ignition key is in the ON position.
    • Verify the scan tool operation with a known good vehicle.
    • Refer to MODULE COMMUNICATIONS NETWORK to diagnose the PCM does not respond to the scan tool.
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, retrieve and record the continuous memory DTCs.
  8. Clear the continuous DTCs and carry out the self-test diagnostics for the PAM  .
  9. If the DTCs retrieved are related to the concern, go to DTC CHARTS . For all other DTCs, refer to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
    PID CHART

    PID Description
    LRI_DIST Left rear inner sensor distance to object
    LRO_DIST Left rear outer sensor distance to object
    RRI_DIST Right rear inner sensor distance to object
    RRO_DIST Right rear outer sensor distance to object
    LRI_ATTEN Left rear inner sensor attenuation
    LRO_ATTEN Left rear outer sensor attenuation
    RRI_ATTEN Right rear inner sensor attenuation
    RRO_ATTEN Right rear outer sensor attenuation
    TRANSGR Transmission gear position
scientia non olet · About LEMON Manuals